Firewalls

For firewalls the EPS is closely tied to the number of connections handled. Most firewalls offer on board reporting that can extract this information or offer vendor documentation on the maximum number of connections per second a model supports.

Palo Alto Networks

  • Via CLI: Use the management server (Panorama) or local firewall CLI to see log rates.

    • Command: debug log-receiver statistics

    • Look for the Log Ingestion Rate or Logs Received counters.

  • Via Log Count: Go to Monitor > Logs > Traffic, filter for the last 60 seconds, and check the count.

Fortinet (FortiGate)

  • Via CLI: Use the following command to see real-time log stats:

    • get log status

    • This shows total logs for different categories (Traffic, Virus, etc.). To get EPS, note the count, wait 10 seconds, run it again, and divide the difference by 10.

  • FortiAnalyzer: If you have FortiAnalyzer, go to System Settings > Dashboard to see the "Log Ingest Rate" widget.

Cisco Firepower / ASA

  • Firepower (FTD): Go to the Firepower Management Center (FMC).

    • Health > Health Monitor. Look for the Event Ingress rate metrics.

  • ASA: ASA doesn't have a native EPS command. You must use show traffic to see packets and estimate, or use an external Syslog server (like Splunk or ELK) to count incoming events.

Check Point

  • Via SmartConsole: Open the Logs & Monitor view. The statistics pane often shows the rate of logs being indexed.

  • Via CLI (Expert Mode): Use the command cpview.

    • Navigate to History > Log-Stat to see historical and real-time log rates.


tags:

  • EPS Firewalls

  • SIEM Sizing